Hello.
I just purchased a Mark V from a friend. He bought it new about 30 years ago. The serial number is 84361.
Am I able to put a saw guide (upper and lower) on the table? It is the original small one.
Thanks.
upper and lower saw guides
Moderator: admin
easiest answer is to buy the retrofit saw guard setup from shopsmith and you will be setdmsokol wrote:Hello.
I just purchased a Mark V from a friend. He bought it new about 30 years ago. The serial number is 84361.
Am I able to put a saw guide (upper and lower) on the table? It is the original small one.
Thanks.
Mark 7, Pro Planer, Jointer, Bandsaw w/Kreg, Biscuit Joiner, Belt Sander, Jig Saw, Ringmaster, DC3300, Overarm Pin Router, Incra Ultimate setup
JWBS-14 w/6" riser, RBI Hawk 226 Ultra, Bosch GSM12SD Axial Glide Dual Compound Miter Saw
-- I have parts/SPTs available, so if you are in the Seattle area and need something let me know --
damagi AT gmail DOT com
JWBS-14 w/6" riser, RBI Hawk 226 Ultra, Bosch GSM12SD Axial Glide Dual Compound Miter Saw
-- I have parts/SPTs available, so if you are in the Seattle area and need something let me know --
damagi AT gmail DOT com
retrofit guards
Thank you. I couldn't find one. Would you happen to have a part number?
This should work for ya.
http://www.shopsmith.com/ownersite/cata ... system.htm
http://www.shopsmith.com/ownersite/cata ... system.htm
SS 500(09/1980), DC3300, jointer, bandsaw, belt sander, Strip Sander, drum sanders,molder, dado, biscuit joiner, universal lathe tool rest, Oneway talon chuck, router bits & chucks and a De Walt 735 planer,a #5,#6, block planes. ALL in a 100 square foot shop.
.
.
Bob
.
.
Bob