wiredone wrote:I think that I would love to see their units so we can put this to rest.
I hate beating dead horses. They start smelling funny after a while.
IIRC, Alec was one, and I cannot recall the 'other' who happens to have two goldies of which one was a Poly-v and one a Gilmer.
Trouble with this horse is, it was once thought to be laid to rest.
I hate inconsistencies and lack of understanding.
Yes it can be said 'who gives a rats a$$', but if one is contemplating acquiring either bench tubes or end castings tis best to unnerstan the possibility of a mis match.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
easterngray wrote:If I thought in the past that mine were 1 7/8", I was incorrect. I just took the calipers to mine and they are 1 3/4. Alec
Thank you for checking. My 'recollection' could be inaccurate! I may be connecting with 3/4hp motor.
Ya gots SN?
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
