Wooden Tool Holder

Meester · Post by **Meester** » Tue Jun 26, 2012 9:23 pm

I just purchased a Shopsmith Mark V, model 500, 1982 I think. Anyway, I'm still trying to figure out how to clean it up. It didn't come with a manual. Anyway, my question is hopefully simple. There is a board attached to the legs of the SS about a foot off of the floor. I know it's to hold all of the attachments but for the life of me I don't know what attachment goes where. So far it is just a piece of wood with some holes and dowels and slots on it. Ok I have figured out where a couple of things go. I was wondering if someone had one and could take a picture of it loaded with the attachments so I could see where things go. That's all, more questions to come later about cleaning and oiling and . . . Now off to the store to find some Johnson floor wax.

cincinnati · Post by **cincinnati** » Tue Jun 26, 2012 10:38 pm

http://www.shopsmith.com/ownersite/cata ... helf_l.jpg

Or

http://www.shopsmith.com/ownersite/prod ... yShelf.pdf

paulmcohen · Post by **paulmcohen** » Wed Jun 27, 2012 12:32 am

Most likely it is the second link above. The top link is for a newer shelf but it also could fit a 500. If you have the newer one use the bottom link as a guide of where to put stuff.

Meester · Post by **Meester** » Wed Jun 27, 2012 2:31 pm

Wow, I didn't expect such a quick reply. My shelf is very similer to these, but not exactly the same. I think the guy I bought it from got his shelf later on. Anyway, I think from these pictures I can hopefully figure it out.

JPG · Post by **JPG** » Wed Jun 27, 2012 2:44 pm

Meester wrote:Wow, I didn't expect such a quick reply. My shelf is very similer to these, but not exactly the same. I think the guy I bought it from got his shelf later on. Anyway, I think from these pictures I can hopefully figure it out.

Quick? You posted the ? last night!:D That was almost 14 hours ago!:rolleyes:

dusty · Post by **dusty** » Wed Jun 27, 2012 5:48 pm

JPG40504 wrote:Quick? You posted the ? last night!:D That was almost 14 hours ago!:rolleyes:

First Responder was there in a little over 1 hour.

jspiceraa · Post by **jspiceraa** » Mon Feb 02, 2015 1:19 pm

Go to: http://www.shopsmith.com/ownersite/prod ... yShelf.pdf. There is a PDF file. I would like to see a picture of the board without the tolls. I want to build one. Good luck. Jack

jspiceraa · Post by **jspiceraa** » Mon Feb 02, 2015 1:24 pm

Where may I get a picture of the wooden tool holder without anything on or in it?
Jack

peterm · Post by **peterm** » Wed Feb 04, 2015 5:23 pm

Not sure if this is the one you are looking for:

pabcab · Post by **pabcab** » Thu Dec 22, 2016 5:09 pm

how do I get plans to make one?

Shopsmith Forums

Wooden Tool Holder

Wooden Tool Holder

re: Wooden Tool Holder

Re: Wooden Tool Holder

Re: Wooden Tool Holder

Re: Wooden Tool Holder

Re: Wooden Tool Holder