Way cool! Thanks Chuck.
For anyone else that is interested, there is a picture of this thing on the Popular Woodworking website. I ordered the issue for a whopping $8 (no shipping and handling cost!).
http://www.popularwoodworking.com/articleabstract?aid=14393
So what SS piece do I buy, suggestions....
Moderator: admin
-
Greenvilleguy
- Gold Member
- Posts: 240
- Joined: Thu Jul 20, 2006 12:55 pm
- Location: Greenville, SC
Older Folk
About two years ago artritis and bone spurs in a shoulder hit hard. The mark5 table height and size makes it possible to continue woodworking and the lathe duplicator table and cutter means no death grip on a lathe tool.Good for the hands, and even one off pieces are right there. After the jointer and thickness planner this lathe tool is my favorite.
Rock
Rock
-
paulmcohen
- Platinum Member
- Posts: 1577
- Joined: Fri Dec 08, 2006 8:10 pm
- Location: Beaverton, Oregon
- Contact:
rocke1 wrote:About two years ago arthritis and bone spurs in a shoulder hit hard. The mark5 table height and size makes it possible to continue woodworking and the lathe duplicator table and cutter means no death grip on a lathe tool.Good for the hands, and even one off pieces are right there. After the jointer and thickness planner this lathe tool is my favorite.
Rock
I have a solution to your problem using the Universal Tool Rest (banjo), you can purchase an adapter that will accept any of the Shopsmith lathe duplicator cutters and mount them into an adapter that fits into the tool rest hole. Pictures below, I think it was less than $20.
[ATTACH]952[/ATTACH]
[ATTACH]953[/ATTACH]
- Attachments
-
- Shopsmith 001.jpg (86.87 KiB) Viewed 2195 times
-
- Shopsmith 002.jpg (79.56 KiB) Viewed 2196 times
Paul Cohen
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
Beaverton, OR
A 1982 500 Shopsmith brand upgraded to a Mark 7 PowerPro, Jointer, Bandsaw (with Kreg fence), Strip Sander, Ring Master and lots of accessories all purchased new
12" Sliding Compound Mitre Saw, 1200 CFM DC
Bowl Turning Videos....
I found a series of Bowl Turning videos.
I had a bit of trouble when the sequence was interupted, but watched beginning to drying wet bowls.
There was one with demo on mouting wet wood in a four jaw chuck.
I had a bit of trouble when the sequence was interupted, but watched beginning to drying wet bowls.
There was one with demo on mouting wet wood in a four jaw chuck.
MK V 520; MK V 510 w/PP DIY Upgrade; MK 5 500; Jointer; Bandsaw; Sliding Table; Conical Sanding Disk; Sharpening Guide, Lathe Duplicator, Jigsaw, Scrollsaw, Beltsander, Ring Master, Biscuit Joiner.