First picture is a little blurry, but I think it shows what I am talking about the best.
Does this need to be replaced
Moderator: admin
Does this need to be replaced
This is part of the speed control mechanism. I noticed that turning the dial was pretty rough, of course had to do it while turning the disk sander as I couldn't get the ShopSmith to turn on. I just attributed it to everything being very dirty. After cleaning it up, and applying some 3-in-1 oil, it is still pretty rough to turn. It looks like the teeth are not exactly straight anymore and kind of chewed up. Is this how it supposed to be, or is this wear and tear? If it needs to be replaced can I just replace this specific part, I believe it is the quadrant assembly (part 86 on the parts diagram), or do I need to replace the whole speed control assembly (part 86-96)?
First picture is a little blurry, but I think it shows what I am talking about the best.
First picture is a little blurry, but I think it shows what I am talking about the best.
Read this post: http://www.shopsmith.net/forums/showpos ... stcount=22
Then email member Bill Mayo.
I believe if you take a file to them, the teeth on the quadrant can be straightened sufficiently to salvage. Bill's repair will prevent it from happening again.
Then email member Bill Mayo.
I believe if you take a file to them, the teeth on the quadrant can be straightened sufficiently to salvage. Bill's repair will prevent it from happening again.