Main table insert for tablesaw

creekrunner · Post by **creekrunner** » Thu Oct 04, 2012 11:50 pm

Just acquired an 83 model. Main table missing insert and two screws that hold it in. Anyone on here parting one out? Checked ebay but don't want to go there unless I have to.

Also looking for a good 6" face plate.

David

curiousgeorge · Post by **curiousgeorge** » Fri Oct 05, 2012 12:11 am

Look HERE for the inserts and HERE for the faceplate. That should fix you up, David.

creekrunner · Post by **creekrunner** » Fri Oct 05, 2012 9:26 am

Thanks curiousgeorge, I had found where to buy new and certainly will do that if I have to but I was trying to maybe help out someone on this site that was or is parting out a machine or two.
David

Shopsmith Forums

Main table insert for tablesaw

Main table insert for tablesaw

Parts