Restoring Mark VII

drdale · Post by **drdale** » Thu Oct 11, 2012 2:41 pm

I was given an old VII but it did not have the chuck for the drill set-up. Can anyone tell me the specifics of the chuck I need to look for? Is it the same one the other models use?

Thanks

SDSSmith · Post by **SDSSmith** » Thu Oct 11, 2012 3:18 pm

drdale wrote:I was given an old VII but it did not have the chuck for the drill set-up. Can anyone tell me the specifics of the chuck I need to look for? Is it the same one the other models use?

Thanks

It is the same as used on the other Shopsmith models from the 10E to the current Mark 7. The capacity is 5/64 to 1/2" and it has the 5/8" straight bore for mounting on the quill.

drdale · Post by **drdale** » Thu Oct 11, 2012 4:39 pm

Thanks a lot.