Hi guys
I've noticed that my miter gauge safety clamp doesn't have the "squeeze power" that it used to. My miter gauge face also tends to "shift" during alignment and tightening of the silver knob.
I'm considering disassembling the entire miter gauge and replacing all of the hardware...I will replace any all screws, washers, and etc.
Has anyone else experienced this issue? Any helpful hints that I should consider before I begin? I would prefer to purchase the parts from shopsmith...I just need to research if there is a pre made kit available or if I will need to purchase each piece individually.
Thanks in advance for your help!
Geo
miter gauge with safety grip rebuild
Moderator: admin
How many washers do you have under the silver knob? The miter gauge shifting from the torque of the knob seems to be common if there is only 1 washer. Using 2 washers seems to help with that problem.
Heath
Central Louisiana
-10ER - SN 13927, Born 1949, Acquired October 2008, Restored November, 2008
-10ER - SN 35630, Born 1950, Acquired April 2009, Restored May 2009, A34 Jigsaw
-Mark V - SN 212052, Born 1986, Acquired Sept 2009, Restored March 2010, Bandsaw
-10ER - SN 39722, Born 1950, Acquired March 2011, awaiting restoration
Central Louisiana
-10ER - SN 13927, Born 1949, Acquired October 2008, Restored November, 2008
-10ER - SN 35630, Born 1950, Acquired April 2009, Restored May 2009, A34 Jigsaw
-Mark V - SN 212052, Born 1986, Acquired Sept 2009, Restored March 2010, Bandsaw
-10ER - SN 39722, Born 1950, Acquired March 2011, awaiting restoration