Jointer re-assembly question

[eartigas]

I recently posted about my $500 treasure of SS tools and as I am going through cleaning and refurb I will need help that I'll post here.
Attached is the photo of the jointer that came with the set after cleaning and de-rusting. Only the surface was lightly rusted and the fence quite rusted but not terrible.

In my eagerness to disassemble I did not take proper notes for re-assembly and my problem is about the position of the washers in the stud that holds the in and out tables together. The attached picture refers.

Now, how those six washers are positioned? How many in each side of the tables?

I put half on each side but I am not sure it is right.

Thanks for you assistance

[judaspre1982]

=================================

[eartigas]

Great, thanks.