Set Screw For Flat Sanding Disc Arbor

Mike907 · Post by **Mike907** » Sun Feb 24, 2013 7:23 pm

It's just as well that they left - most of Alaska has been bucking the global warming trend and has been getting colder for the last decade.

Mike

SDSSmith · Post by **SDSSmith** » Mon Feb 25, 2013 1:21 pm

What type of set screw is securing the inner tube? It should be a half dog type, that is it should have a protruding tip with a flat head that fits in the groove of the outer tube and only contacts the inner tube.

algale · Post by **algale** » Mon Feb 25, 2013 1:34 pm

Wrong post, perhaps??

Mike907 · Post by **Mike907** » Mon Feb 25, 2013 3:15 pm

Nothing to do with setscrews, but in the previous post, Dusty had commented about his granddaughter and her husband leaving Anchorage.

Mike

algale · Post by **algale** » Mon Feb 25, 2013 3:20 pm

Someone else made a post, since deleted, intended to respond to another thread.

JPG · Post by **JPG** » Tue Feb 26, 2013 1:05 am

FWIW, I have made flat end set screws from both serrated and cup end by grinding the ends 'flat'. I put a slight bevel on them by grinding at an angle..

dusty · Post by **dusty** » Tue Feb 26, 2013 4:53 am

JPG40504 wrote:FWIW, I have made flat end set screws from both serrated and cup end by grinding the ends 'flat'. I put a slight bevel on them by grinding at an angle..

Huh? You put a bevel on set screws?