Thanks Guys
I will have a look!!
Motor help for another member!
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Take a pix and let us see also!;)greg1m53 wrote:Thanks Guys
I will have a look!!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Motor running
Hello
here is the motor running, it was a little noisy, but used a little Move it lube on it and there is a lot less noise. as per video.
I have ordered new bearing and going to rebuild it.
http://youtu.be/rUsZYS1z9_s
here is the motor running, it was a little noisy, but used a little Move it lube on it and there is a lot less noise. as per video.
I have ordered new bearing and going to rebuild it.
http://youtu.be/rUsZYS1z9_s