What do you think the value of a used one in good running condition is?
Does anyone know what the height of the bandsaw table is when installed on one of these? Is it the same as on the SS main unit?
Shopsmith Power Station
Moderator: admin
-
johnwilliamson062
- Gold Member
- Posts: 60
- Joined: Sat May 25, 2013 1:31 am
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
The power station spindle is slightly more than 3" lower than the ss spindle, so a mounted bandsaw table should be closer to the floor by the same amount.
A used power station is worth whatever a seller and buyer can agree on. that will vary by region. They are not all that commonly available used. IMHO $200 is a good median figure, but that is just that - opinion. Condition will affect that.
A used power station is worth whatever a seller and buyer can agree on. that will vary by region. They are not all that commonly available used. IMHO $200 is a good median figure, but that is just that - opinion. Condition will affect that.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
