PowerPro Low Voltage
Moderator: admin
PowerPro Low Voltage
Finished my DIY powerpro upgrade. When I turn off power switch, get low voltage error for about 10 seconds and then a few flashes before shutdown. All else seems to function properly. Is this normal?
-
fredsheldon
- Platinum Member
- Posts: 1175
- Joined: Tue Jan 17, 2012 1:31 pm
- Location: The Woodlands, Texas
I believe this is normal. I have noticed that on mine as well but I don't pay attention to it anymore. 
Fred Sheldon
The Woodlands, Tx
'52 10ER # 60869 (restored in 2012, used as a dedicated drill press), '52 10ER # 88712 (restored 01/2013), 52 10ER # 71368 (in process of restoring), '83 500 Shorty with OPR installed, '83 520 PowerPro with Lift Assist, 6" Joiner, 6" Belt Sander, 18" Jig Saw, 11" Band Saw, 12" ProPlaner, SS Crosscut Table. SS Dust Collector, Hitachi 1/2" router, Work Sharp 3000 with all attachement, Nova G3 Chuck, Universal Tool Rest, Appalachia Tool Works Sled.
The Woodlands, Tx
'52 10ER # 60869 (restored in 2012, used as a dedicated drill press), '52 10ER # 88712 (restored 01/2013), 52 10ER # 71368 (in process of restoring), '83 500 Shorty with OPR installed, '83 520 PowerPro with Lift Assist, 6" Joiner, 6" Belt Sander, 18" Jig Saw, 11" Band Saw, 12" ProPlaner, SS Crosscut Table. SS Dust Collector, Hitachi 1/2" router, Work Sharp 3000 with all attachement, Nova G3 Chuck, Universal Tool Rest, Appalachia Tool Works Sled.
-
texomawood
- Gold Member
- Posts: 91
- Joined: Mon Apr 08, 2013 9:16 am
- Location: Texoma, Tx
If you read the manual you will find it buried in there that there is a "power saver" feature on the power pro, so that if you turn off the power switch by mistake you have approximately 10 sec to turn the power switch back to on and not loose your settings. It is a nice feature if you turn the switch off by mistake instead of using the red off push button.
My only problem is I forget when leaving the shop to turn the switch off so that I don't have an inadvertent start by somebody playing with buttons or a power surge damaging the control board.
My only problem is I forget when leaving the shop to turn the switch off so that I don't have an inadvertent start by somebody playing with buttons or a power surge damaging the control board.
