I think some insulating tubing would be appropriate there.
(over both wires twisted together).PowerPro keeps tripping breaker and arcing at plug
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
So how did your wires get out from under the sleeve and into the gears(and untwisted to boot)?
I think some insulating tubing would be appropriate there.(over both wires twisted together).
I think some insulating tubing would be appropriate there.
(over both wires twisted together).╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
greasetattoo wrote:OK everyone, fixed the problem...
I am going to run them a different way rather then around the Quill assembly.
Whew.....
Thanks for all the help!
If you do the upgrade, make sure and run your wires so nothing touches them!
The re-routing should solve your problem:D . Notice in the video http://www.shopsmith.com/shopsmithpowerpro/pp_diy.htm (1:32 to 1:45) those two wires never do touch the quill parts. Also that clip is a big help, if one is available.
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA