found jig

farley · Post by **farley** » Sun Aug 04, 2013 4:52 pm

left in the shop of the house I brought are many jigs, I am sure there are plenty of "one offs", which I'll never used. When I have a little down time, I try to figure them out. I am totally lost on a bunch. Here is one that is quite well made, so the accuracy should be there.

I figure it can be used as a slot cutter for edge jointer.

notice on pix. three, there are rails on the bottom to make sure it is pushed in equal on both sides.

pix. four shows a slot I made

-

wasatch · Post by **wasatch** » Mon Aug 05, 2013 8:12 am

It looks to me like it was made to create tenon cheek cuts on a table saw.

farley · Post by **farley** » Mon Aug 05, 2013 8:22 am

I agree and he had a mortise machine

JPG · Post by **JPG** » Mon Aug 05, 2013 9:13 am

But But But What is it resting upon in the first pix?:D

And those roller thingies!!!

dusty · Post by **dusty** » Mon Aug 05, 2013 9:28 am

JPG40504 wrote:But But But What is it resting upon in the first pix?:D

And those roller thingies!!!

I think I know. In fact, I think you know.

It is resting on a non-Shopsmith table saw that is equipped with a home made outfeed table with rollers.

JPG · Post by **JPG** » Mon Aug 05, 2013 9:30 am

dusty wrote:I think I know. In fact, I think you know.

It is resting on a non-Shopsmith table saw that is equipped with a home made outfeed table with rollers.

Yes indeed! And very nice roller thingies as well!

farley · Post by **farley** » Mon Aug 05, 2013 10:38 am

Dusty is right, it's is a Non SS piece of crap Table Saw, with no fence.

The jig was made for that table saw, I have to take off the runners and make some for my SS. I only hope the previous owner didn't glue the runners in. more work if he did.

rose23 · Post by **rose23** » Tue Aug 06, 2013 12:18 am

Nice working to make to well balanced. The wood quality is also looking very
fine.