dcohenour wrote:Yeah, I thought about that, IF you could pry it off from the front. Maybe that is what a previous owner was thinking. Now there is a nut on the back side.
What could I turn this hole into? How about a light hooked up to the power switch to let me know that it is on? hehe
Maybe I could mount an old cigarette lighter in the hole....
Mount a mirror, so I could watch myself use the SS?
Oh! How about a "headstock-cam"?
Seriously tho, a gooseneck light might not be a bad idea...
Uh huh, just make sure it can be 'positioned' completely out of the way(always).
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
dcohenour wrote:Not sure what to use on the aluminum table top surfaces tho...
I'm not sure what state your table surfaces are in but in general remove any crud and oxidation and then give them a coat of MinWax or Johnson's Paste Wax and then buff them well to remove any excess wax. Stuff should slide on them like butter after that and this will minimize any future oxidation issues (assuming you repeat this on a reasonable maintenance interval. Same maintenance for your way and bench tubes, risers tubes on tables and jig saw etc.
'78 Mark V 500 #27995 (my Dad bought new)
'82 Mark V 500 #96309
Two '47 10E's (serial#4314+6149) - one a dedicated drill press and the other a lathe
Two 10E/ER in parts slowly being restored…#26822 and #????? (SS plate missing)
SPT's: Bandsaw, Belt Sander, Strip Sander, Jointer, Jigsaw, Biscuit Joiner
