Table question

ipbarnard · Post by **ipbarnard** » Sat Jan 04, 2014 7:16 pm

Just wondering.

What are the two extra bolts on the bottom of my Mark V table for?

Thanks,
Foster From Flint

beeg · Post by **beeg** » Sat Jan 04, 2014 7:38 pm

Those are for when ya have it in drill press mode, so that the table is horizontal.

reible · Post by **reible** » Sat Jan 04, 2014 7:59 pm

beeg wrote:Those are for when ya have it in drill press mode, so that the table is horizontal.

Those need to be adjusted as does the 45 degree stop. Part of a good check-up of the machines alignment.

Ed

charlese · Post by **charlese** » Sat Jan 04, 2014 8:04 pm

Yeah! What Beeg said! They ain't "extra" - they're necessary! I found them very useful.
Glad you looked down there!:D

JPG · Post by **JPG** » Sat Jan 04, 2014 10:10 pm

charlese wrote:Yeah! What Beeg said! They ain't "extra" - they're necessary! I found them very useful.
Glad you looked down there!:D

They be adjustable 'stops'.