cantputt wrote: Well, yes it sure is, pretty cold right now up her in Michigan. Is this going to be a problem? Never dreamed that could be a problem. If this is a summer only tool it probably is going back on Craigslist.
Cantputt, I have a really good friend in Bismarck, ND. In 2001 post 9/11 after we were activated (Air National Guard) we also got enrolled in Air War College. Anyone who has spent a year doing that will tell you it's a bonding experience and we both went on to make full colonel when it was all said and done, pinning on the same day. In any event, I digress only to make the point that we are very close friends. She loved my SS and so got herself a 520 new after she retired from the military. She had the same experience as you in her garage.
This past August I helped her and her husband raise the roof on her 20x20 heated garage addition and designated shop. Look at the positive side, here is your opportunity to get that heated garage you always wanted.
"... and it was after long searching that I found the carpenter's chest, which was indeed a very useful prize to me, and much more valuable than a ship loading of gold." Daniel Defoe, Robinson Crusoe, 1719
wa2crk wrote:Do NOT continue to try to start the motor if it hust hums. Doing so WILL burn out the motor windings. The belts may be stuck in the sheaves or the start switch inside the motor is clogged with the debris.
Clean the interior of the headstock with a vacuum and or some compressed air to clean out any sawdust.
Then try to start it again and if it hums turn it off IMMEDIATELY.
You may want to try installing the sanding disc on the main spindle and the turn the disc by hand. If it turns easily then the mechanical stuff is most likely OK. If you still have problems check back here for more info.
And bye the way, WELCOME!!
Bill V
Thanks, I will open things up and get a better look tonight. I had a bumpy, snowy 1 1/2 hour transport so maybe something happened. I did have it tied down very well in an enclosed trailer.
WmZiggy wrote:Cantputt, I have a really good friend in Bismarck, ND. In 2001 post 9/11 after we were activated (Air National Guard) we also got enrolled in Air War College. Anyone who has spent a year doing that will tell you it's a bonding experience and we both went on to make full colonel when it was all said and done, pinning on the same day. In any event, I digress only to make the point that we are very close friends. She loved my SS and so got herself a 520 new after she retired from the military. She had the same experience as you in her garage.
This past August I helped her and her husband raise the roof on her 20x20 heated garage addition and designated shop. Look at the positive side, here is your opportunity to get that heated garage you always wanted.
Broke out the old torpedo heater and warmed up the garage while I did my snowblowing.. I used the walls from an EZ Up to close things off a little. Wam bam the old SS fired right up. So glad I have that issue behind me.
cantputt wrote:Ya, that's coming our way. Snowing hard right now and we have plenty on the ground. Tomorrow is going to be nasty cold and blowing.
Where yat?????
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Western Michigan. We get constant lake effect snow from the cold air coming across the warmer water of Lake Michigan. My house is on the eastern edge of the Lake effect so I am not as bad as people along the lake shore. Right now we are deep in snow. South of us they are ticketing anybody driving today it is so bad.
