Mystery Part on E-Bay

dgale · Post by **dgale** » Thu Jan 23, 2014 10:56 pm

Just curious if anyone can identify this part on E-Bay:
http://www.ebay.com/itm/ShopSmith-Part-/221359474124?pt=Power_Tools&hash=item338a0d85cc

I assume it's from a 10ER based on the knob but I can't place the specific part...

skou · Post by **skou** » Thu Jan 23, 2014 11:12 pm

It is a part of the ER jointer/shaper fence. Unless someone needs that particular casting, the price is too high.

(Besides the Mk5 500 model will work on the ER table, and in my opinion works better. I've got both.)

steve

dgale · Post by **dgale** » Thu Jan 23, 2014 11:44 pm

Ah, thanks - that explains it as I've never seen a 10ER jointer.

skou · Post by **skou** » Fri Jan 24, 2014 1:59 am

dgale wrote:Ah, thanks - that explains it as I've never seen a 10ER jointer.

Want one? Like I said, the Mkv 500 one is better, and I've got both. (Oh, it's just the jointer/shaper fence.)

The ER fence mounts in the hole for the table saw insert, the MkV 500 one mounts on the front and back of the table. Also, the infeed is micro-adjustable. the ER is trial and error.

steve

dgale · Post by **dgale** » Fri Jan 24, 2014 9:06 am

No…I have a MV jointer…just was curious what the part was as I hadn't seen one before and couldn't place it.

skou · Post by **skou** » Fri Jan 24, 2014 5:42 pm

The thing I'm talking about, is a 3 inch jointer head, that mounts on the quill, with the Shopsmith in drill-press mode. The fence, would do the same as the infeed or outfeed tables on a real jointer. You can also set the fence up in line, for shaping the edge of a piece of wood, when you're just removing part of the thickness.

You can also set it up in normal (horizontal) mode, with the table tipped 90 degrees, and use the fence as the infeed/outfeed table. It will also work with the 3 inch drum sander.

steve

JPG · Post by **JPG** » Fri Jan 24, 2014 5:58 pm

skou wrote:The thing I'm talking about, is a 3 inch jointer head, that mounts on the quill, with the Shopsmith in drill-press mode. The fence, would do the same as the infeed or outfeed tables on a real jointer. You can also set the fence up in line, for shaping the edge of a piece of wood, when you're just removing part of the thickness.

You can also set it up in normal (horizontal) mode, with the table tipped 90 degrees, and use the fence as the infeed/outfeed table. It will also work with the 3 inch drum sander.

steve

Sure about that?;)

skou · Post by **skou** » Fri Jan 24, 2014 6:06 pm

[quote="JPG40504"]Sure about that?]

I currently don't have one, but my memory is; 3 inches long, and 2.5 inches in diameter.

Oh, go and check out the listing. Yes, I sent him a message.

steve