Double tilt assemblyÂ…

JPG · Post by **JPG** » Sat Mar 01, 2014 11:58 pm

joedw00 wrote:If you are talking about the motor being reverseable no it's not. It just puts the headstock up instead of down like drill press mode.

I thought I saw an extra switch. Cannot tell what it actually is. Still makes sense!;)

joedw00 · Post by **joedw00** » Sun Mar 02, 2014 11:47 am

I replaced the original switch with just a toggle switch. I replaced the original one two times and said the heck with that. Maybe that is what you see.

JPG · Post by **JPG** » Sun Mar 02, 2014 11:54 am

joedw00 wrote:I replaced the original switch with just a toggle switch. I replaced the original one two times and said the heck with that. Maybe that is what you see.

???????????????????
[ATTACH]24223[/ATTACH]

joedw00 · Post by **joedw00** » Sun Mar 02, 2014 12:09 pm

I replaced this [ATTACH]24224[/ATTACH] with one like this [ATTACH]24225[/ATTACH]

idcook · Post by **idcook** » Sun Mar 02, 2014 12:42 pm

Traditional router table arrangement. Nice.

Having an individual set up for the purpose I hadn’t considered this.

Thanks Joe.

joedw00 · Post by **joedw00** » Sun Mar 02, 2014 1:22 pm

That is the biggest reason I wanted a double tilt because I don't have room for a router table. I don't use it in router mode much but when I want it doesn't take long to have a router table.