Lathe Centers and the 10ER

cluksha · Post by **cluksha** » Thu May 29, 2008 4:21 pm

Can someone tell me if the stock Lathe centers for the Mark V will work on the 10 ER?

There are no dimensions listed on the parts catalog page (http://www.shopsmith.com/ownersite/catalog/l_lathecenters.htm)

Thanks so much!
Chris

RobertTaylor · Post by **RobertTaylor** » Thu May 29, 2008 7:52 pm

while i do not have a model 10er i am ninety-nine and forty-four one-hundreths percent sure that all shopsmith centers are interchangeable. bob

joedw00 · Post by **joedw00** » Thu May 29, 2008 8:23 pm

I have a 10 ER, and a 520 and they will work on either one.

cluksha · Post by **cluksha** » Thu May 29, 2008 10:10 pm

Thank you so much!

Then I will purchase them

I just didn't want to waste the time/money/effort if it wasn't going to work.

thanks again,
Chris