I was asked in a PM to post a picture of it so I thought I would just post a link to the original thread on the build. I believe a picture is in post #13.
And no it is not fully finished yet... but it is fully functional and has an extra caster set on it. I am still quite pleased with the concept and just want to add some little things to it that I had planned from the start like shelves and a simple cable counter-weight system to make head and table adjustment easier.
.
--
farmer
Francis Robinson
I did not equip with Shopsmiths in spite of the setups but because of them.
1 1988 - Mark V 510 (bought new), 4 Poly vee 1 1/8th HP Mark V's, Mark VII, 1 Mark V Mini, 1 Frankensmith, 1 10-ER, 1 Mark V Push-me-Pull-me Drillpress, SS bandsaw, belt sander, jointer, jigsaw, shaper attach, mortising attach, TS-3650 Rigid tablesaw, RAS, 6" long bed jointer, Foley/Belsaw Planer/molder/ripsaw, 1" sander, oscillating spindle/belt sander, Scroll saw, Woodmizer sawmill
Thanks Farmer. I'd like to see the counter balance setup when you're done.
Jim
Hello from Somerset in the beautiful Pennsylvania Laurel Highlands.
Mark 7, Mark VII, Mark V 520, Mark V 510 x 2, Mark V 500
SPT's - Band Saw, Jig Saw, Belt Sander, Jointer, strip sander, Oscillating Sander, Speed Increaser
SS Freestanding - Pro Planer, Scroll Saw, Overarm Pin Router, Power Station, DC3000 x 2
Made for SS - Incra iBox, Ring Master
but it is fully functional and has an extra caster set on it. I am still quite pleased with the concept and just want to add some little things to it that I had planned from the start like shelves and a simple cable counter-weight system to make head and table adjustment easier.