Model 10e

matthew · Post by **matthew** » Tue Jun 17, 2008 7:53 pm

Can Anyone Tell Me What A Model 10e Is Worth,

billmayo · Post by **billmayo** » Tue Jun 17, 2008 10:01 pm

As much as someone will pay. I normally buy them for $20-$100 if no speed changer, joiner or jigsaw. If no metal ends and/or retractable casters, then $50 is the most I will pay for an average run-of-the mill 10E/10ER. For a totally restored one with all accessories and new paint, then $200-$300 is not bad. They make an excellant drill press and a cheap way to start doing some wood working. All 10E/10ER parts can be replaced/repaired/rebuild and they last forever if you take care of the rust and corrosion.

matthew wrote:Can Anyone Tell Me What A Model 10e Is Worth,

Nick · Post by **Nick** » Tue Jun 17, 2008 11:34 pm

"...they last forever..."

And, with a little encouragement, they will clone new, improved copies of themselves. We use about two dozen 10E's in the manufacture of Shopsmith Mark Vs.

With all good wishes,

matthew · Post by **matthew** » Wed Jun 18, 2008 5:12 pm

Thanks For The Replys On The 10e.

easterngray · Post by **easterngray** » Wed Jun 18, 2008 7:09 pm

We use about two dozen 10E's in the manufacture of Shopsmith Mark Vs.

Is that true Nick? That's remarkable - How are they used? Photo's of the SS manufactring process would be awesome!! Alec

wonderdog · Post by **wonderdog** » Fri Jun 20, 2008 10:05 pm

I just picked up 10ER with jigsaw but w/o coupling or blades. Are couplings available from SS and what type blades should I be looking for?

I paid $100.00 with jigsaw-runs pretty good. It's a lot heavier than my
56' MK 500.

chas410 · Post by **chas410** » Tue Oct 19, 2010 9:21 pm

I am the proud new owner on a 10E. I'd like to replace the motor. What would you suggest. Where do you suggest I look for one. Thanks in advance for your help. Chas

Shopsmith Forums

Model 10e

Model 10e

Model 10e

10e

10ER motor