Incra I-Box

[ExtraMile]

Does anyone have this, for their SS Mark V?

Pros/Cons

Please advise!

[Gene Howe]

I do and I love it!
Once it is set up it is very easy to produce excellent joints.

[ChrisNeilan]

I bought one last year and got very frustrated. I'm sure it was me, not the jig. I'm a little impatient sometimes. I think I'll dig it out today and give it another try! It is very well made.

[reible]

Hi,

Yes a few of us here have them. I think rather then add new comments I will refer you to a couple of posts from the past.

http://www.shopsmith.com/ss_forum/woodw ... 12807.html

http://www.shopsmith.com/ss_forum/gener ... 13257.html

Hope this helps.

Ed

[mbcabinetmaker]

I have one for my unisaw. It works great.

[ExtraMile]

Thank you, for your replies

[moggymatt]

I have one and love it. I use it as much on my router table if not more than my shopsmith. Get a good flat btm Dado if get one for the saw. So many dado blades claim a flat bottom but still cut lititle wings.

[claimdude]

Paul,

Do you have a miter bar for your router table and one for the SS? I have an Incra router table so the miter slot is standard 3/8 x 3/4. Thinking about getting the I-Box.

Jack

[Gene Howe]

I have one and love it. I use it as much on my router table if not more than my shopsmith. Get a good flat btm Dado if get one for the saw. So many dado blades claim a flat bottom but still cut lititle wings.

The Freud box joint dado set does a good job. Also, If your blade sharpening service has the skills, you can have any dado set re ground to produce absolute flat bottoms.

[moggymatt]

Paul,

Do you have a miter bar for your router table and one for the SS? I have an Incra router table so the miter slot is standard 3/8 x 3/4. Thinking about getting the I-Box.

Jack

No, my router table is home made with the slot sized to fit my shopsmith gear.