Anyone have SS sharpening jig, found here: http://www.shopsmith.com/ownersite/cata ... rpener.htm
Is it worth getting?
Please advise!
Sharpening?
Moderator: admin
Sharpening?
I am a true blue Xylophiliac, who also is a Nemophiliac 
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Sharpening?
Yes it is 'worth getting'.ExtraMile wrote:Anyone have SS sharpening jig, found here: http://www.shopsmith.com/ownersite/cata ... rpener.htm
Is it worth getting?
Please advise!
It is also easy to make one. A 1/8" 45 degree slot(or whatever angle suits). Table tilt to change angle.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: Sharpening?
Yes! quite a few members have and use them. Only issue I've found is adjusting the spring washers supplied with the tool. I replaced them with smaller ones from Lowe's. Problem with the original was they interfered with mounting the blades straight.ExtraMile wrote:Anyone have SS sharpening jig
Is it worth getting?
Please advise!
Octogenarian's have an earned right to be a curmudgeon.
Chuck in Lancaster, CA
Chuck in Lancaster, CA