Will later miter gauges fit the 10er, or is the table slot a different size?
I am in need of one. I note they are a bit pricey in eBay.
Don
Miter gauge with hold down fir 10er
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Miter gauge with hold down fir 10er
The "10" miter gauge bar is 3/4" wide. Mark 5... miter gauge bars are slightly narrower.dlewis wrote:Will later miter gauges fit the 10er, or is the table slot a different size?
I am in need of one. I note they are a bit pricey in eBay.
Don
Also the "10" miter gauge bar is 1/4" thick. The Mark 5... is thicker.
That means the "10" miter gauge slot is shallower.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Re: Miter gauge with hold down fir 10er
I have not tried this but I think it being made by Skip pretty much says it will work fine.
http://mkctools.com/10ermiterbarmv.htm
Ed
http://mkctools.com/10ermiterbarmv.htm
Ed
{Knight of the Shopsmith} [Hero's don't wear capes, they wear dog tags]
Re: Miter gauge with hold down fir 10er
Thanks for the help.
Dom
Dom