replacing spring #504196
Moderator: admin
replacing spring #504196
I had to replace all of the bearings on my 1957 model Mark V. "long story short" I do not remember where spring #504196 goes on the speed control. Can some send me a pic of its position?
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: replacing spring #504196
See third pix. It is 'upside down'.
http://www.shopsmith.com/ss_forum/viewt ... #post40966
More often it just gets lost. That is the 'anti-rattle' spring.
IMHO it is the speed going past saw-joint tactile feedback spring.
http://www.shopsmith.com/ss_forum/viewt ... #post40966
More often it just gets lost. That is the 'anti-rattle' spring.
IMHO it is the speed going past saw-joint tactile feedback spring.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange