12x20x8 high shop (240 sq. ft. heat with 18,000 btu direct vent
heater .. (propane) insulated concrete floor with pink 1 1/2
styarafoam insulation.. even when it is 20 below zero here in
Minnesota takes about one hour to make it 65 degrees. don't have to heat
the concrete every time ,..walls are 2x4, ceiling is 2x8 fiberglass insulation. floor is also easy on the legs. covered insulation with plyboard.
How do you heat your shop?
Moderator: admin
Re: How do you heat your shop?
- Attachments
-
- IMG_3993.JPG (69.08 KiB) Viewed 1605 times
-
ERLover
- Platinum Member
- Posts: 3914
- Joined: Mon Aug 31, 2015 10:19 pm
- Location: Greenie and Goldie Country not to metion the WI Badgers!
Re: How do you heat your shop?
oldc6,
sounds cozy!!!! no need to go indoors
sounds cozy!!!! no need to go indoors
KNOWLEDGE AND EXPERIENCE EQUALS WISDOM. Albert Einstein
The Greatness officially starts
Greenie, Grayling, SS stand alone BS and BS SPT, jointer and belt sander, 3 Ers with Speed Changers. I think those 3 cover my ER needs, and space for them.
The Greatness officially starts
Greenie, Grayling, SS stand alone BS and BS SPT, jointer and belt sander, 3 Ers with Speed Changers. I think those 3 cover my ER needs, and space for them.
Re: How do you heat your shop?
I think I need to SLAP you, Bra.keakap wrote:We heat our shops out here by turning off the air conditioning.
I used to live a few miles away from you.
(What is upper Kalihi, Mauka or Makai?)
steve
10 ER, stripped down.
Basic 10ER, Parts machine. Will be a semi-dedicated drill-press machine.
10 ER, a "survivor" of the trailer fire, in the back yard, needing restoration. Has a Mk5 headrest. Finally, stripped down.
Numerous parts, for Model 10 stuff. Except for lower saw guard, A and B adapters, I've got it.
Looking for one more, or some 9 inch extension table raisers.
Basic 10ER, Parts machine. Will be a semi-dedicated drill-press machine.
10 ER, a "survivor" of the trailer fire, in the back yard, needing restoration. Has a Mk5 headrest. Finally, stripped down.
Numerous parts, for Model 10 stuff. Except for lower saw guard, A and B adapters, I've got it.
Looking for one more, or some 9 inch extension table raisers.