- IMAG0344-1280x720.jpg (125.98 KiB) Viewed 972 times
Found part, need help identifying
Moderator: admin
Found part, need help identifying
Just found this laying in my SS cabinet. Not sure what this came out of, hoping one of you recognise it.
Found it where I store the saw blades, arbors, safety stuff, etc... But it is also right under the shopsmith. The top of the bolt is not slotted, it's Smooth and the are slight "wings" off the head.
Found it where I store the saw blades, arbors, safety stuff, etc... But it is also right under the shopsmith. The top of the bolt is not slotted, it's Smooth and the are slight "wings" off the head.
-Beave
Re: Found part, need help identifying
That looks like part of the plastic featherboard. Inserts through the bottom of the plastic featherboard's short plastic miter bar.
Gale's Law: The bigger the woodworking project, the less the mistakes show in any photo taken far enough away to show the entire project!
-
dusty
- Platinum Member
- Posts: 21530
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Re: Found part, need help identifying
Right on!algale wrote:That looks like part of the plastic featherboard. Inserts through the bottom of the plastic featherboard's short plastic miter bar.
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.
Re: Found part, need help identifying
Exactly it, thanks for helping me out on that. Would have been a while before I found that out. (i have multiple feather boards)
Thanks
Thanks
-Beave