I remember but maybe not accurately. I seem to think that I set up for that thread and showed how it could be done with the lift assist still installed.JPG wrote:Remember Ed's thread?dusty wrote:I too am in my 70's and not getting any younger. I too appreciate the lift assist though right now I have it off (laying on my work bench in pieces).
However, I do not understand your declaration that you "took it off to facilitate 45° cuts" (not a quote). Please explain.
Long pieces will not clear the base casting since the table carriage range is restricted.
I also built a temporary sled for the thread and because I had some long floor material to miter. Sled was marginally successful.
