The plan is to mount the 510 powerhead and table on the Mark VII/7 (old one) and sell the Mark VII/7 powerhead, table and tubes. I was wondering how much I should ask. The speed contril is in good shape though the reverse just hums. Also the rack gear on the tube is in good shape.
Any suggestions would be appreciated.
Mark VII/7 (Old One) Powerhead Values
Moderator: admin
-
Steamdragon
- Gold Member
- Posts: 137
- Joined: Sat Aug 01, 2015 12:50 am
- Location: San Jose, CA
-
JPG
- Platinum Member
- Posts: 35599
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Mark VII/7 (Old One) Powerhead Values
Small market, low demand but they tend to be fanatics.
I hope you include the carriage etc..
I do not know what it can fetch.
The reverse problem is likely the switch(if original).
FWIW I paid $300 for an entire 'functioning' one, but it needed a lot of tlc etc..
I hope you include the carriage etc..
I do not know what it can fetch.
The reverse problem is likely the switch(if original).
FWIW I paid $300 for an entire 'functioning' one, but it needed a lot of tlc etc..
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange