Your machine is just fine. Like ER said (sorta), note where the carriage and headstock were located when she went to drill press mode. She had the bulk of the weight left of center (near the pivot point). What she ended with would not have been a comfortable drill press position. The table was too far to her right (thus too close to the floor) when upright.
Consider adding the lift assist.
"Making Sawdust Safely" Dusty
Sent from my Dell XPS using Firefox.
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
charlese wrote:By Gollie! and Sorry! This is the first time I have to disagree with Dusty.
I always place the table in it's lowest position. The Headstock in an appropriate location for drilling.
1) It makes lifting a whole lot easier.
2) I always sit on a stool when drilling vertically.
You would love a Mark VII.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Especially if your Mark VII has a working gear rack like mine. I run it to the right and tip it up. Then crank it up to a useful height. If the gear racks had been made of a more durable material they would be something MarkV series owners would lust after.
reible wrote:Is it time to vote someone off the island?
Ed
That action is, IMO, long over due but since it does not happen I spend a lot less time here. I guess you could call it "avoidance" but that is the best I can do.
"Making Sawdust Safely" Dusty
Sent from my Dell XPS using Firefox.
reible wrote:Is it time to vote someone off the island?
Ed
That action is, IMO, long over due but since it does not happen I spend a lot less time here. I guess you could call it "avoidance" but that is the best I can do.
The objectionable posts(as well as some responses to them) have disappeared.
Doubt they will be missed.
I am more tolerant than many here, but they were uncomfortable to me!
Hence the responses.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Apologies if I offended anyone. At the risk of sounding like one of my kids, I took my cue from some of the replies--which didn't feel -that- risque. But what do I know. Message received.