Featherguard retrofit kit installation instructions

[Sazerac81]

Does anyone have pdfs or some high res pictures of the featherguard upgrade kit installation instructions for the jointer?

Much appreciated if you could provide them to me.

Cheers!
John

[Sazerac81]

Well, if no one has any readily available instructions, can anyone explain or grab a quick picture as to how the locking nut/hand knob mechanism is secured to the table?

Is it simply screwed into a tapped hole into the in-feed table off of little peninsula?

A picture of how it is secured to the infeed table with feather guard assembly would be much appreciated!

Cheers,
John

[JPG]

Never laid eyes nor hands on one.

However since it is a 'retro kit', I presume it fits into the hex shaped hole the same as the 'original'.

What is 'added' is the tapped hole for the stud that allows locking it in position(rotation).

[trjohns22]

hope this is what your looking for.

[Sazerac81]

Exactly what I needed trjohns! Thank you much!