jigssaw part

hobbies · Post by **hobbies** » Thu Oct 20, 2016 6:23 pm

does anyone knows where i can get the plastic part that make the blade go up and down on 18 inch jig saw dont have part number

jsburger · Post by **jsburger** » Thu Oct 20, 2016 6:36 pm

hobbies wrote:does anyone knows where i can get the plastic part that make the blade go up and down on 18 inch jig saw dont have part number

The plastic part?

Please explain.

hobbies · Post by **hobbies** » Thu Oct 20, 2016 6:40 pm

goes inside the main unit on the botton

Mike907 · Post by **Mike907** » Thu Oct 20, 2016 6:48 pm

Do you mean the part being fabricated in this video?

https://www.youtube.com/watch?v=Rb17icIjzeA

If so, it's a Yoke Bracket Assembly, part no. 502275, and not available as far as I know.

Mike

hobbies · Post by **hobbies** » Thu Oct 20, 2016 7:16 pm

hobbies · Post by **hobbies** » Thu Oct 20, 2016 7:24 pm

does this have to be plastic?

Mike907 · Post by **Mike907** » Thu Oct 20, 2016 9:42 pm

I notice that in a four year old comment beneath the video, Skip Campbell at MKC Tools had made some and had them in stock. I couldn't find them listed on his site, but you could give him a call.

http://mkctools.com/

Mike

jsburger · Post by **jsburger** » Fri Oct 21, 2016 1:11 pm

hobbies wrote:goes inside the main unit on the botton

Oh, OK. I haven't looked in there in a long time.

everettdavis · Post by **everettdavis** » Sat Oct 22, 2016 12:52 am

The video show how to fabricate one out of a piece of cutting board plastic in about 10 minutes.

I have a brand new OEM part on a NOS Jig Saw I bought last week and was thinking of making one of those due to the age of the plastic.

Everett

hobbies · Post by **hobbies** » Thu Nov 10, 2016 6:05 pm

why is it so loud?

Shopsmith Forums

jigssaw part

jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part

Re: jigssaw part