thunderbirdbat wrote:Part of the issue is that I have never had a router table before. I am attempting to figure out what type of track I want to put in the table. I was thinking either the SS track or a combination track. By using a cut wood track to start with, I can figure out if I can use some of my existing jigs or the miter gauge on the router table. I can enlarge the cut track to put the aluminum track in after I decide which I want.
Makes sense!
That leaves the 'where to put it' question.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
