It must have been one of those days.
The table is aligned and it happened with no difficulties. The one thing that I did a little bit different is leave the trunnion bolt at the pivot point tighter. To move the table, I needed a small rubber mallet.
Finalizing Main Table Alignment
Moderator: admin
-
dusty
- Platinum Member
- Posts: 21530
- Joined: Wed Nov 22, 2006 6:52 am
- Location: Tucson (Wildcat Country), Arizona
Re: Finalizing Main Table Alignment
"Making Sawdust Safely"
Dusty
Sent from my Dell XPS using Firefox.
Dusty
Sent from my Dell XPS using Firefox.