Magna jigsaw table wobble
Moderator: admin
-
stilllearning
- Bronze Member
- Posts: 5
- Joined: Fri Jul 04, 2014 3:45 pm
Magna jigsaw table wobble
Have searched the forums but can't find anything on the following problem. Am setting up an old (model 610) Magna jigsaw (aerial number indicates from late 1950s) and I can't keep the table from moving. Have tightened everything down, but can still grip the leading edge of the table and rock it up and down about 1/16th of an inch. Thanks in advance for any ideas you might have.
-
JPG
- Platinum Member
- Posts: 35600
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Magna jigsaw table wobble
Are the trunion mounting screws tight? Is the trunion clamping knob tight?
i.e. is the table moving AND the trunion also moving?
i.e. is the table moving AND the trunion also moving?
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange