- IMAG0624-1280x720.jpg (168.47 KiB) Viewed 2993 times
Also after the previous I despise bevels on a Shopsmith comments I decided to try again and did 192 bevel cuts at 30 degrees. Now I'll just despise 45s, because the 30s were not that bad.
Sometime a SS table is too small...
Moderator: admin
Sometime a SS table is too small...
Sometimes a Shopsmith has to small of a table. So sometimes I use two.
Cross cutting an 8' long piece of plywood is hard, so I needed more support. Wheeled over my other and now I have all the support I need. Whoever thinks shopsmiths can't handle the job just doesn't have enough of them.
Also after the previous I despise bevels on a Shopsmith comments I decided to try again and did 192 bevel cuts at 30 degrees. Now I'll just despise 45s, because the 30s were not that bad.
Cross cutting an 8' long piece of plywood is hard, so I needed more support. Wheeled over my other and now I have all the support I need. Whoever thinks shopsmiths can't handle the job just doesn't have enough of them.
Also after the previous I despise bevels on a Shopsmith comments I decided to try again and did 192 bevel cuts at 30 degrees. Now I'll just despise 45s, because the 30s were not that bad.
-Beave
-
masonsailor2
- Platinum Member
- Posts: 1564
- Joined: Wed Feb 05, 2014 11:57 am
- Location: Las Vegas NV
Re: Sometime a SS table is too small...
Hear hear !
Paul
Paul
-
rjent
- Platinum Member
- Posts: 2121
- Joined: Fri Mar 14, 2014 3:00 pm
- Location: Hot Springs, New Mexico
Re: Sometime a SS table is too small...
Right on! 
One of the main arguments for having multiple SS's if you have room IMHO. I set the 10ER's as outfeed for plywood sheets with the M5 as an infeed support. Never felt uncomfortable ....
One of the main arguments for having multiple SS's if you have room IMHO. I set the 10ER's as outfeed for plywood sheets with the M5 as an infeed support. Never felt uncomfortable ....
Dick
1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 jigsaw X 2
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin
1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 jigsaw X 2
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin