My little shop

[Danriffle]

Small, but packed with shopsmithy goodness!

[Danriffle]

An explanation of the clutter:

In the extreme foreground, the handle of my Yuba Sawsmith.
Clamped to the saw table is a spare 10er table with shaper fence.

Foreground is a 10E (primarily TS and dado duty).
Has a 3/4 HP 3450 rpm motor and 2 step drive pulley.

Hiding behind that is a MkV, my newest acquisition.
It came with a bandsaw. Still putting it through it's paces.

Completely hidden against the right wall is another 10ER.
It's the lathe, disk & drum sander, and horizontal drill press.

In the corner is yet another 10ER as a dedicated drill press.

(Not pictured, still another 10ER that I have on a job site.)

[Dansmith]

You must really like 10er's. What's not to like? Nice shop.

[Danriffle]

You must really like 10er's. What's not to like? Nice shop.

Exactly! And thanks!

[masonsailor2]

Nice shop ! Best part is it is obviously used a lot.
Paul

[Danriffle]

Nice shop ! Best part is it is obviously used a lot.
Paul

Thanks! I do make mountains of sawdust!

[JPG]

An interesting 'addition'!

holddown.jpg (2.93 KiB) Viewed 7567 times

[Danriffle]

An interesting 'addition'!holddown.jpg

Ha,ha! These machines are designed for ingenuity.

That's a hold down I use for dadoes. It's cobbled together from a blade guide from a old 10er scroll saw, parts from an old SS universal hold down set and an ancient spring loaded rubber caster that appeared in my junk bin at some point.

It works surprisingly well!