Exercising my Bowl Gouge

This is a forum for intermediate to advanced woodworkers. Show off your projects or share your ideas.

Moderator: admin

Post Reply
Dansmith
Gold Member
Posts: 489
Joined: Fri Feb 03, 2017 2:02 pm
Location: Idaho

Re: Exercising my Bowl Gouge

Post by Dansmith »

Don, did you turn that on a Shopsmith? It is very nice.
Top
dgreen810
Gold Member
Posts: 478
Joined: Sun Dec 15, 2013 3:17 pm
Location: Tulsa Area

Re: Exercising my Bowl Gouge

Post by dgreen810 »

Dan

Yes I did on a Mark V

Don G
Top
dgreen810
Gold Member
Posts: 478
Joined: Sun Dec 15, 2013 3:17 pm
Location: Tulsa Area

Re: Exercising my Bowl Gouge

Post by dgreen810 »

I have been looking at it this morning and contemplating flatting the bottom but don't want to risk breaking it. It's only about 3/16" thick.

Don G
Attachments
IMGP0147.JPG
IMGP0147.JPG (544.02 KiB) Viewed 4989 times
Top
Dansmith
Gold Member
Posts: 489
Joined: Fri Feb 03, 2017 2:02 pm
Location: Idaho

Re: Exercising my Bowl Gouge

Post by Dansmith »

dgreen810 wrote:Dan

Yes I did on a Mark V

Don G
Thanks.
Top
dgreen810
Gold Member
Posts: 478
Joined: Sun Dec 15, 2013 3:17 pm
Location: Tulsa Area

Re: Exercising my Bowl Gouge

Post by dgreen810 »

SS disc sander to the rescue!
Don G
Attachments
IMGP0150.JPG
IMGP0150.JPG (515.67 KiB) Viewed 4969 times
IMGP0151.JPG
IMGP0151.JPG (504.06 KiB) Viewed 4969 times
IMGP0152.JPG
IMGP0152.JPG (455.02 KiB) Viewed 4969 times
Top
Post Reply

Return to “General Woodworking”