Let me rephrase that! Ohm's law is simply E=IR only when applied to resistive circuits.
Add reactive components and trig must enter the equation.
Hello!! And Help!!!
Moderator: admin
-
JPG
- Platinum Member
- Posts: 35598
- Joined: Wed Dec 10, 2008 7:42 pm
- Location: Lexington, Ky (TAMECAT territory)
Re: Hello!! And Help!!!
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
-
chapmanruss
- Platinum Member
- Posts: 4534
- Joined: Tue Aug 26, 2014 8:16 pm
- Location: near Portland, Oregon
Re: Hello!! And Help!!!
The Shopsmith Mark 5 or V (depending on if it was made before or after 1980) motor runs at 3450 RPM. That is true for both the 3/4 and 1-1/8 HP motors. It would be difficult to find a lower RPM motor to replace it with. It has a longer shaft and very specific mounting points. The idea of changing pulley sizes between the idler shaft and the drive shaft is an interesting one but not possible inside the belt cover. There is not enough room inside the housing to change the speed with custom made pulleys. There already is a speed reduction between the idler shaft and the drive shaft.