Make sure you watch this all the way through. This guy has taken it to a whole new level. Some great ideas. He does some bowl turning that you won't believe. CNC on a lathe
[youtube]https://www.youtube.com/watch?v=477l4gGLSdk[/youtube]
wood turning taken to a whole new level
Moderator: admin
-
rjent
- Platinum Member
- Posts: 2121
- Joined: Fri Mar 14, 2014 3:00 pm
- Location: Hot Springs, New Mexico
wood turning taken to a whole new level
Dick
1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 jigsaw X 2
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin
1965 Mark VII S/N 407684
1951 10 ER S/N ER 44570 -- Reborn 9/16/14
1950 10 ER S/N ER 33479 Reborn July 2016
1950 10 ER S/N ER 39671
1951 jigsaw X 2
1951 !0 ER #3 in rebuild
500, Jointer, Bsaw, Bsander, Planer
2014 Mark 7 W/Lift assist - 14 4" Jointer - DC3300
And a plethora of small stuff .....
"The trouble with quotes on the Internet is that you can never know if they are genuine." - Benjamin Franklin
-
davebodner
- Gold Member
- Posts: 476
- Joined: Sun Nov 09, 2008 4:38 pm
- Location: Arlington, VA
Re: wood turning taken to a whole new level
I didn't take the time to view the video. I hope to later. I'm replying merely to promote something relevant to the top of the stack, in front of the spam.
-
twistsol
- Gold Member
- Posts: 256
- Joined: Mon Feb 22, 2016 9:35 pm
- Location: Cottage Grove, MN
- Contact:
Re: wood turning taken to a whole new level
I watched this video and the thought of cleaning up the mess afterward was terrifying. The chips and dust looked to be about a barrelful a minute.
Other than that, it was extremely cool to to watch, expeically the segmented turning done in the second half.
Other than that, it was extremely cool to to watch, expeically the segmented turning done in the second half.
Thanks much,
Chris Phelps
Cheap tools are too expensive
2x Mark 5 520 and a 10ER
Chris Phelps
Cheap tools are too expensive
2x Mark 5 520 and a 10ER
Re: wood turning taken to a whole new level
That segmented turning of the large vase was done on a Nova DVR lathe with the same motor as the PowerPro. It has different gearing, though. The PP won't get down to 100 rpm.
Mike
Mike