Next project before I start cranking out wood. Make a dust collector like Jim Roadifer https://youtu.be/rCVBWPOr09M He's doing it on a Mark with more spacious table slot than my 10er. I only have 3 inches which doesn't leave much with 2" pvc. Used the Dado set that came with it again to carve out the ends of a 3" wide slab of nylon I recived as a gift.
Then bought another HF horror to make the 2 3\8" hole in a 2x4. Going to put 4 screws into it & see if it holds up. If not i'll have to make 2 piece of nylon.
Finished and it works perfect. Catches 90% of the saw dust. Most of the dust in the picture after cutting 6 1/8" shims was from forgetting to turn on the Shopvac for one cut after I changed the shot 8" to a new Skill 7 1/4".
I used a 3" long piece of thin wall 2" 45% ell & a female adapter. Shopvac hose screws in tight.
Last edited by RAnst4038 on Wed May 01, 2019 12:40 pm, edited 1 time in total.
Why would you want to do this? I know I would feel a lot safer have a lower saw guard. If you accidentally reached under the table while the saw was running, this would be a very dangerous setup. Do you not have a lower saw guard for your Shopsmith?
RFGuy wrote:Why would you want to do this? I know I would feel a lot safer have a lower saw guard. If you accidentally reached under the table while the saw was running, this would be a very dangerous setup. Do you not have a lower saw guard for your Shopsmith?
10ER's came with an upper guard, but not a lower.
There was a lower guard sold as an accessory, but they are extremely rare.
I use a lower guard for a Mark 5 on mine, but don't have it connected to dust collection.
lowerguard.3.jpg (329.13 KiB) Viewed 18687 times
Ron Dyck
==================================================================
10ER #23430, 10ER #84609, 10ER #94987,two SS A-34 jigsaws for 10ER.
1959 Mark 5 #356595 Greenie, SS Magna Jointer, SS planer, SS bandsaw, SS scroll saw (gray), DC3300,
The YouTube video that was posted shows this on a Mark V (500). Haven't these always had a lower saw guard, or did the 500 also start with no lower saw guard?
The Mark 5 did NOT come with either guard. Optional extra cost only.
But that was almost 60 yrs ago.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
RF Guy
