My local pen-kit dealer already told me I'm getting a bit "rich" in my tastes. I'm mostly going for the 'designer' kits, like some of these:
Anyway, I'm wondering if any of you are going for higher-end pens. Also, any favorite functional features? For example, I've never tried a Fountain pen... have any of you? I'd love to hear more on what you've made and how they work for you.
I have not gone to anything high end. The most expensive pens I've turned were the coffee ones which are about $10 per blank and I wrecked one of those so I'm only 2 for 3 but with newer tools and better techniques I could do better now.
I stay to the low end since I give the pens away. Both the kits and wood/plastic blanks need to be very reasonable due to the volume I've done.
One thing I regret is not keeping better records, and now I've lost count but I know it hast to be in the area of 375 including the ones now in process. If I paid say even $15 for wood and kits that would have amounted to $5625. As it is the amount if far less, Somewhere in the $5 each range. Of course there was the up front cost for the tools and then the reoccurring costs for supplies.
I'm actually trying to get out of the business, it is no long as much fun as it once was. I'm not one to like to make a lot of something. I'm turning 6 more pens to go with the last batch of 17 I just finished up. That about does it for my blank supply but I must have maybe another 10 pen kits to go. Saving a few of those to take up by my brothers so I can let him have a go at pen turning. He's 83 so it is about time he gives this a go.
I did try to break in the Rockler nib, but the lines were always blotchy and I was always scratching the paper.
I did see a few kits that allowed a variety of ink delivery systems (siphon, cartridge and bulb), but they were from companies that appeared to only sell fountain pens. When I start back again, I’ll go with a better quality kit, but it’s going to be a gift.
As a side note, there are instructions that let you make the threaded sections from the wood or acrylic pieces, but that skill is so far above me that I’ll stick with the kits that have the metal threaded pieces.
For a while the Bullet kits were very popular. But now the Steampunk Kit from Penn State Industries is the rage. Can't make them fast enough. Even selling them at Real Mother Goose in downtown Portland.
Examples of my work-
Top pen is Snakewood. The Steampunk is spalted Briar Burl. And the bottom one is Amboyna Burl.
I do not recommend Snakewood as it cracks most of the time.
- AssortedPens.jpg (223.37 KiB) Viewed 18173 times
Shopsmith 10ER S/N R39267; purchased 10-10-50 in San Francisco.