Selling all my SS and shop equipment

[dgreen810]

Hi All

Selling all my stuff mostly on Craigslist Tulsa (Broken Arrow), OK. Hate to leave but medical issues have taken over.

Don G

[dusty]

Hi All

Selling all my stuff mostly on Craigslist Tulsa (Broken Arrow), OK. Hate to leave but medical issues have taken over.

Don G

So very sorry to hear this Don. I hope that all goes well for you in the future.

Rest assured, ours prayers will be with you and yours throughout..

[berry]

That must be very difficult, I know I'd have a hard time letting go.

[wa2crk]

Don
I am very sensitive to your plight. I may be going down that same road sooner than expected. The wife and I are both approaching 80 and the yard and housework can sometimes exceed our limits. Check back in sometimes even if it is only to chat.
Regards;
Bill V

[thunderbirdbat]

Very sorry that you will no longer be able to produce saw dust. I think I speak for all here when I say, we will still want your opinions on any questions asked. Your knowledge is still needed here.

[jsburger]

Best wishes Don. I totally agree with Brenda and the others.

[dms8667]

Don,

I share others’ comments. Please continue to post and
share your knowledge as I have learned a lot from your posts and comments.

Blessings,

Danny

[JPG]

Ditto!!!!

[Ed in Tampa]

I am quickly coming to that time in life where it might be better to stay out of the shop. I do not use my Shopsmith that much anymore mostly just home handyman stuff, but it seems when I do I forget something.

The Shopsmith is like an old single reflex camera. To take a picture you must set film speed, adjust aperture, set shutter time, check lighting, install flash if needed, focus and zoom in or out. I am getting to be a more point a shot person.

I use my Shopsmith and I forget something be it table height, fence lock down, carriage lock. Quill lock, speed, table levelness, out feed support, wheel lock down, push stick, hold down, etc.

I do it often enough that it scares me, which is one of the reasons I do not use it more. Last time I was using the molder and to make sure everything was right I was applying good pressure on the wood. The table height was not tight enough and I pushed the wood down onto the molder head. Needless to say the excitement it caused rocked me. I stopped and haven't used the Shopsmith since.

Single use equipment and me get along much better. They are just a dangerous but in most cases all I need to remember is where my fingers are.

Oh yes I now buy the molding I want instead of trying to make it.