In another thread, it was noticed the Sawdust Sessions link was broken.
I also cannot access them from the the link on the Shopsmith homepage nor can I locate them on YouTube (where they were also previously posted). I can only find some of the old Shopsmith Hands Online videos on YouTube but these are only some of the old "interludes" Nick did, which were shorter videos.
I hope this is just a website maintenance issue rather than a deliberate decision to remove the Sawdust Sessions permanently from the Shopsmith site. Even though the video quality/resolution was terrible by today's standards, the information in the sessions was absolutely priceless!
Sawdust Sessions Taken Down?
Moderator: admin
Sawdust Sessions Taken Down?
Gale's Law: The bigger the woodworking project, the less the mistakes show in any photo taken far enough away to show the entire project!
Re: Sawdust Sessions Taken Down?
The domain name registration doesn't expire for another year, so hopefully it is just a temporary issue with the servers where the website resides.
- ShopsmithAcademy.jpg (75.5 KiB) Viewed 4186 times
RF GuyMark V 520 (Bought New '98) | 4" jointer | 6" beltsander | 12" planer | bandsaw | router table | speed reducer | univ. tool rest
Porter Cable 12" Compound Miter Saw | Rikon 8" Low Speed Bench Grinder w/CBN wheels | Jessem Clear-Cut TS™ Stock Guides
Festool (Emerald): DF 500 Q | RO 150 FEQ | OF 1400 EQ | TS 55 REQ | CT 26 E
DC3300 | Shopvac w/ClearVue CV06 Mini Cyclone | JDS AirTech 2000 | Sundstrom PAPR | Dylos DC1100 Pro particulate monitor