Arbor with male 5/8" thread end to use regular saw blades

[GPelham]

I just picked up a used Mark V and it came with the shopsmith 1 1/4 inch arbor and a very old blade. I have many 10 in blades for my miter, radial arm and table saws and would like to use them with the MV table saw. On line I can only find the adapter with a 1 inch threaded end, which is needed for lathe attachments so I bought one. Anyone know where to purchase one with 5/8 inch thread?

Thanks
Gary

[jsburger]

https://www.shopsmith.com/ownersite/cat ... arbors.htm

[GPelham]

Thank You,

[chapmanruss]

You did not say which Mark V you have and it can make a difference on which 5/8" Blade Arbor to get. The original Mark V aka 500 uses a shorter Arbor than the Mark V 510, 505, 520 and Mark 7. Both are listed on the link John gave you.

[GPelham]

Thank You as well for helping a newbee