Intermittent squealing/squeaking after rebuild...?

Forum for Maintenance and Repair topics. Feel free to ask questions or contribute.

Moderator: admin

DLB
Platinum Member
Posts: 2308
Joined: Fri Nov 08, 2019 11:24 am
Location: Joshua Texas

Re: Intermittent squealing/squeaking after rebuild...?

Post by DLB »

See Page 4, steps 2.a and 2.b:
https://shopsmith.com/ownersite/product ... cement.pdf

Go figure. Some small difference in 'B' and 'C' casting dimensions??? I did not see anything like that in the PP DIY install manual. Which seems like it would share in whatever they are thinking.

- David
User avatar
JPG
Platinum Member
Posts: 35600
Joined: Wed Dec 10, 2008 7:42 pm
Location: Lexington, Ky (TAMECAT territory)

Re: Intermittent squealing/squeaking after rebuild...?

Post by JPG »

Thank You for posting those instructions. Perhaps this is an explanation for differing opinions regarding proper location of the poly-v belt on the drive sleeve pulley.

So we have a new mystery to ponder. i.e What is different in the "C" casting????

I assume I am correct in that the sliding medallion(hole cover) was introduced with the "C" casting.

Well I can relax! New thing learned for today already before noon!!!
╔═══╗
╟JPG ╢
╚═══╝

Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10
E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
Post Reply