I disagree that there is no 'mechanical stop'. That occurs when the short straight part at the end of the camming surface contacts the fence body/wear plates. This occurs with All lever type fence clamps.
I do agree that one should NOT be able to move the lever further(at that point the parts are jamming together. That click you hear is the cam going slightly 'over the center' into the stopped position.
More wind uncontaminated by actual hands on experience.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
JPG wrote:I disagree that there is no 'mechanical stop'. That occurs when the short straight part at the end of the camming surface contacts the fence body/wear plates. This occurs with All lever type fence clamps.
I do agree that one should NOT be able to move the lever further(at that point the parts are jamming together. That click you hear is the cam going slightly 'over the center' into the stopped position.
More wind uncontaminated by actual hands on experience.
Mechanical stop in quotes. It only becomes a "mechanical stop" if the nut is adjusted properly. The OP has not tightened the adjustment nut sufficiently. All of this applies to the upper handle also.
Exactly!
John & Mary Burger
Eagle's Lair Woodshop
Hooper, UT
Thanks for all the responses. I have now followed your suggestions about the correct positions of the locking levers and it seems to be working. I am really impressed with the quality of the advice and the nice tone of the comments despite my obvious lack of knowledge.
joegez12 wrote:Thanks for all the responses. I have now followed your suggestions about the correct positions of the locking levers and it seems to be working. I am really impressed with the quality of the advice and the nice tone of the comments despite my obvious lack of knowledge.
There is not an 'expert' here that has not seen action in thy shoes. So no reason to be other than helpful.
Glad you got it working correctly(been a long time coming!_.
╔═══╗
╟JPG ╢
╚═══╝
Goldie(Bought New SN 377425)/4" jointer/6" beltsander/12" planer/stripsander/bandsaw/powerstation /Scroll saw/Jig saw /Craftsman 10" ras/Craftsman 6" thicknessplaner/ Dayton10"tablesaw(restoredfromneighborstrashpile)/ Mark VII restoration in 'progress'/ 10E[/size](SN E3779) restoration in progress, a 510 on the back burner and a growing pile of items to be eventually returned to useful life. - aka Red Grange
It only becomes a "mechanical stop" if the nut is adjusted properly. The OP has not tightened the adjustment nut sufficiently. All of this applies to the upper handle also.
