Parts for Restoration - North Texas

[krzink]

I have parts available for anyone restoring an old 500 machine, including:
Headstock with new belt (updated to use 3-wire power) (missing screws) Serial Number trace says made in 1954 - ran well before I upgraded to Power Pro headstock.
Extension Table (no legs)
Main Table and Carriage
Rip Fence
Holder for Tool Rest
A few miscellaneous pieces

I need to clean out the garage, and would prefer to see these go to good use. $125, or best offer.
Photos available.

[dusty]

Let me know where you are located. I am interested.

[krzink]

I'm in McKinney.

[curtisslough]

I came across your post on CL this morning haha.

I've got a '59 Mark V that I'm going to be restoring this fall, will the parts from the '54 work on the '59?

[krzink]

To the best of my knowledge, yes.

[chapmanruss]

The main changes that occurred to the Mark 5 between 1954 and 1959 was in the Headstock. The Headstock casting changed from the "A" to the "B" headstock and some changes/additions were made to the Idler Shaft Mounting. The Drive Sleeve was changed to a "clutched" version. Both had the Gilmer Drive.